Easy Setup Guide GM 150
Items not included: - Phillips screw driver - Flat head screw driver F Camera support G Screen mount support H Back cover Screen support Shelf x1 M Front glass Acrylic platform Items included C O Top frame B Q A Philips head bolt 1/4"x 3/4" x6 T x2 V Base Rack Bolt and nut x1 x4 Glass hinge x11 U Lock Philips head bolt 5/16"x1 1/4" S R Flange nut 1/4" Side panels x4 x2 x4 P Philips flat head 1/4" Blind nut 1/4" Carriage bolt With break 2 Without break 2 x8 Multi wr
Place the wider side of the top frame in the front of the cart and place the slot face down. C Follow these steps in one corner at a time. R To fit the lateral flange with the top frame C holes press until click and secure with bolt R. 4 B Note: hand tighten bolts then proceed to step 4, once glass door is installed then tighten the bolts for the top frame. Fit the hinge with the glass in the top frame hole. Place the other hinge S in the base A and slide the glass.
6 Fit the back cover J bracket into the side panel hole. J Slide the back cover J flanges into the base A. 7 Place the shelf I flanges into the rack squares. Secure the back cover with the philips head bolt R. First, insert the cage nut U into the rack squares at the desire height from the inside. Outside I Inside Screw the shelf with two bolts U into the cage nuts U. Compresing the padlock, slide the lock handle and the washer thru the cilinder as shown in the sequence.
9 F Place the screen mount support F in the top D, sliding the flange into the rectangular hole and fit two carriage bolts N in the squares. Q N 10 Fix the mount support F with flange nuts Q from the inside of the cart using the multi wrench V. 11 H Attach the acrylic L to the camera support G with the philips flat head bolts O. P O Attach the screen support H with four philips head bolts P at the desired height. Note: See instructions inside screen support box to mount flat screen on cart.
