Operation Manual

Error Messages in Windows Me/98/95
96 Controller B1 v3.0 – 16 Troubleshooting
Error Messages in Windows Me/98/95
Error message: “Controller-xx with I/O address <xxx> could
not be found”
Possible cause: The position of the jumper that sets the I/O
address on the ISDN-Controller does not correspond to the
entry in the Control Panel (Device Manager), or the hardware
is not installed.
Remedy: The I/O address set with the jumper must corre-
spond to the entry in the Device Manager. Open the Device
Manager by clicking through “Settings / Control Panel / Sys-
tem” and select the AVM ISDN-Controller B1 v3.0. Click
“Properties” there and then the “Resources” settings page.
Use the “Change setting” button to adapt the I/O address to
the jumper position on the ISDN-Controller. If Windows indi-
cates a device conflict for the desired I/O address, another
address must be set, first with the jumper on the ISDN-Con-
troller, and then again in the Device Manager.
The computer must be restarted for these settings to take ef-
fect.
Error message: “Interrupt <xx> not available” or “Interrupt
<xx> cannot be used”
Possible cause: The AVM ISDN-Controller B1 v3.0 and an-
other hardware device (such as a sound card) are set to the
same interrupt.
Remedy: Open the Device Manager by clicking through “Set-
tings / Control Panel / System” and select the AVM ISDN-
Controller B1 v3.0. Click “Properties” there and then the “Re-
sources” settings page. Select the resource type “Interrupt”.
Use the “Change setting” button to set a different interrupt
which is not used by any device. Windows automatically in-
dicates any conflicts with other devices. The computer must
be restarted for these settings to take effect.
HB_B1V30.book Seite 96 Mittwoch, 7. Februar 2001 3:19 15