Operation Manual

Changing the Settings
60 ISDN-Controller B1 v3.0 – 9 Installation in MS-DOS
To load the driver for the AVM ISDN-Controller B1 v3.0 auto-
matically each time the computer is started, add the call for
the IBASE.BAT batch procedure to the AUTOEXEC.BAT file.
(Remember to include the path!).
9.4 Changing the Settings
The following settings can be changed:
l D-channel protocol
l activate automatic data compression (CAPI SoftCom-
pression X75/V42bis)
Start the installation program again by entering the
in-
stall
command as described in the section “Installing the
Driver Software” on page 56 and follow the instructions
there.
Information about CAPI SoftCompression is available in the
section “CAPI SoftCompression X75/V42bis” on page 83.
9.5 Installing Additional Controllers
Up to four active AVM ISDN-Controllers may be installed in
your computer at the same time. It is also possible to com-
bine active AVM ISDN-Controllers for ISA and PCI buses in on
computer.
To install additional ISDN-Controllers, proceed as follows:
1. Open the ISDNLOAD.CFG file from the installation direc-
tory in a text editor.
2. Copy the entire section beginning with the line [ISDN-
Controller-00]. Enter the copied section again below the
original section.
3. Then add one to each of the controller numbers in the
new section and enter the desired values for the sec-
ond controller:
– I/O address and interrupt
HB_B1V30.book Seite 60 Mittwoch, 7. Februar 2001 3:19 15