Operation Manual

Configuring the ISDN-Controller B1 v3.0
44 ISDN-Controller B1 v3.0 – 7 Installation in Windows 95
7.2 Configuring the ISDN-Controller
B1 v3.0
In the second step of installation, change the jumper posi-
tion on the AVM ISDN-Controller B1 v3.0 if necessary. Use the
value suggested by the Add New Hardware Wizard. Upon de-
livery, the jumper is set to the I/O address 150 (see the sec-
tion “Setting the I/O Address” on page 14).
Once the ISDN-Controller has been installed in Windows 95
and the jumper has been set, the ISDN-Controller B1 v3.0 can
be physically installed in the computer.
7.3 Physically Installing the ISDN-
Controller B1 v3.0
For the physical installation of the AVM ISDN-Controller
B1 v3.0 and the connection of the cables, follow the steps
described in the section “Installing the ISDN-Controller
B1 v3.0 in the Computer” on page 15.
7.4 Installing the Driver Software
After physically installing the ISDN-Controller B1 v3.0, the
next step is to install the driver software. Proceed as follows:
1. Turn your computer back on. The welcome screen of the
installation program appears. To obtain more informa-
tion about the ISDN-Controller and the installation pro-
cess, click the “Read AVM Readme” button.
Use the “F1” key at any time to view a help text for the
current installation step.
Click “Next”.
2. Select the ISDN-Controller to be installed. For informa-
tion about the controllers listed, click the “Info” button.
Click “Next”.
3. In the next window, enter the folder in which the driver
software of the AVM ISDN-Controller B1 v3.0 is to be in-
stalled. When your entries are complete, click “Next”.
HB_B1V30.book Seite 44 Mittwoch, 7. Februar 2001 3:19 15