Operation Manual

Installation in Windows 98
ISDN-Controller B1 v3.0 – 6 Installation in Windows 98 35
6 Installation in Windows 98
For use in Microsoft Windows 98, specially developed driv-
ers are included with delivery. The driver architecture corre-
sponds to the architecture of the Microsoft Win 32 Driver
Model (WDM). This true 32-bit device driver offers full sup-
port for all features of Microsoft Windows 98.
The CAPI 2.0 supplied with the controller supports both 16-
bit and 32-bit applications and, at the same time, applica-
tions in DOS windows. For more information about CAPI, see
the section “The Applications Interface CAPI 2.0” on
page 78.
The AVM ISDN-Controller B1 v3.0 is installed in Windows 98
in four main steps:
1. Installing a new hardware device using the Windows Me
Hardware Wizard
2. Configuring the controller
3. Physically installing the controller
4. Installing the driver software
The individual steps are described in detail below.
6.1 Installing the New Hardware Device
Do not physically install the ISDN-Controller hardware in
your computer first.
Proceed as follows for installation:
1. Open the “Add New Hardware” folder in the Control
Panel (“Start / Settings / Control Panel”).
The Windows 98 Add New Hardware Wizard appears.
This wizard assists in the installation of new hardware
devices. Click “Next” to begin installation.
2. The Add New Hardware Wizard announces that it recog-
nizes new Plug and Play devices. Click “Next”.
HB_B1V30.book Seite 35 Mittwoch, 7. Februar 2001 3:19 15