User's Manual

The Call Timer and the Timer features are used to measure elapsed

time on a call.

However, the Call Timer feature can be used ONLY if your telephone

is connected to a DEFINITY ECS Release 6.3 or later. This feature,

once activated, measures elapsed time automatically on all calls until

you turn off the Call Timer feature.

The Timer feature must be turned on for each individual call you wish

to time. At the end of the call, you must immediately turn off the feature.

This feature can be used with any DEFINITY switch release.

Check with your system manager to see if you can use either of these

features.

To use the Call Timer feature to measure elapsed time on telephone

calls

1. Press the Menu button and then press the softkey below CTime

or, if CTime is not available on your display, press the

button (if administered).

The Call Timer will measure elapsed time automatically on all calls

until you turn off the Call Timer feature.

2. When you want to turn off the Call Timer feature, press the Menu

button and press the softkey below CTime

or, if you have activated this feature with , press the

button.

To use the Timer feature to measure elapsed time on an individual

telephone call

1. Press the Menu button and then press the softkey below Timer (which

exits you from softkey mode)

or, if Timer is not available on your display, press the button

(if administered).

2. To stop the timer and clear the display, press the Menu button and then

press the softkey below Timer again

or, if Timer is not available on your display, press again.

Call Timer and Timer

Call Timer

Timer