Administrator's Guide

Using TTI to move phones
Issue 5 October 2002 105555-233-506
removing the feature access code (FAC) from the system when it does not
need to be used (for example, there are no moves going on at present).
Consult the Avaya Products Security Handbook for additional steps to
secure your system and find out about obtaining information regularly about
security developments.
Before you start
Before you can merge a telephone, you must set the TTI State field to voice on the
Feature-Related System-Parameters screen. You also must set the extension to
match the port type of the TTI port making the merge request. For example, a
digital telephone type can merge only to a port on a digital board.
!
CAUTION:
When a phone is unplugged and moved to another physical location, the
Emergency Location Extension field must be changed for that extension or
the USA Automatic Location Identification data base must be manually
updated. If the Emergency Location Extension field is not changed or if the
USA Automatic Location Identification data base is not updated, the DID
number sent to the Public Safety Network could send emergency response
personnel to the wrong location.
NOTE:
You cannot use TTI to change a virtual extension.
Instructions
TTI merge from a voice TTI port
!
CAUTION:
You can destroy your hardware if you attempt to connect an analog
telephone to a digital port.
To merge an extension to a telephone with TTI, complete the following steps from
the telephone you want to merge:
1. Dial the TTI merge FAC.
— If the code is correct, you receive dial tone.
— If the code is not correct, you receive intercept tone.