Configuration Guide

108 Chapter 6 Setting up VoIP trunks for outgoing calls
P0609327 02
Configuring lines and creating line pools
To set up the line configurations, use the line record for each enabled line. All lines that are
assigned to the same line pool should have the same programming.
1 Click on the keys beside Services, Telephony Services, Lines, VoIP lines, Enabled VoIP
lines.
2 Click on the General heading to enter:
• a new name for the line
• a control set for the line
3 Click on the Trunk/line data heading and set the parameters you require for your system. The
line must belong to a line pool that contains the same type of VoIP line.
4 If you want specific restrictions assigned to the lines, fill out the information under the
Restrictions heading.
5 Repeat these steps for all the lines that are active. Ensure that you put the H.323 trunks and SIP
trunks in separate line pools.
Note: Configuring SIP and H.323 trunks in the same line pool may result in unpredictable
results since they do not support the same level of service. SIP trunks, for example, do not
support MCDN-protocol services, T.38 fax protocol, or NetVision-generated calls.
H.323 trunks
SIP trunks
Keycodes: 2