User's Manual

FAS; Reviewed:

RS 7/18/03

Solution & Interoperability Test Lab Application Notes

8 of 11

FoundryILP.doc

• Disable inline power to port 1 and verify that the telephone has lost power

FES2402 Switch(config)#interface eth 1

FES2402 Switch(config-if-e100-1)#no inline power

FES2402 Switch(config-if-e100-1)#show inline power

Power Supply: total capacity is 480000 of which 457600 is currently available

power has been successfully allocated 64 times and rejected 0 times

Port Detection Class Power Enable Power

-------------------------------------------------------------

01 Unknown Unknown OFF No

02 802.3AF-PD Class2 ON Good

03 802.3AF-PD Class3 ON Good

04 Unknown Unknown OFF No

05 Unknown Unknown OFF No

06 Unknown Unknown OFF No

07 Unknown Unknown OFF No

08 Unknown Unknown OFF No

09 Unknown Unknown OFF No

10 Unknown Unknown OFF No

11 Unknown Unknown OFF No

12 Unknown Unknown OFF No

13 Unknown Unknown OFF No

14 Unknown Unknown OFF No

15 Unknown Unknown OFF No

16 Unknown Unknown OFF No

17 Unknown Unknown OFF No

18 Unknown Unknown OFF No

19 Unknown Unknown OFF No

20 Unknown Unknown OFF No

21 Unknown Unknown OFF No

22 Unknown Unknown OFF No

23 Unknown Unknown OFF No

24 Unknown Unknown OFF No

FES2402 Switch(config-if-e100-1)#

Note that the Detection column indicates that inline powering is not configured for port 1.

2. Enable inline power for port 1 and verify that the telephone receives power.

FES2402 Switch(config-if-e100-1)#inline power

FES2402 Switch(config-if-e100-1)#exit

FES2402 Switch(config)#

Table 2 defines the column headings displayed as a result of the show inline power command.