Application Note

•
Select the SIP Common Menu option and press the enter key. The SIP Common1 form
will appear as shown in Figure 34.
• Specify the IP address of the Avaya SES to the 1st IP Address field.
• Return to the Type form (Figure 31) by using the tab key.
• Press the enter key and enter “y” to save the changes to the Hitachi NT-SG.
KN; Reviewed:
SPOC 9/21/2006
Solution & Interoperability Test Lab Application Notes
©2006 Avaya Inc. All Rights Reserved.
36 of 52
NT-SG_AppNote
NT-SG ( 32ch) Module : SIP1
Configuration (SIP Common1)
SIP Server
SIP Server :[ Used ]
1st IP Address :[192.168.135.201]
1st Domain Name :[ ]
1st Port :[5060 ]
1st DNS Domain Name :[ ]
2nd IP Address :[ ]
2nd Domain Name :[ ]
2nd Port :[5060 ]
2nd DNS Domain Name :[ ]
Switch-Over Execute :[Off]
Switch-Back Execute :[Off]
Switch-back Interval(min) :[3 ]
Regist Control :[Regist]
Pre Regist Removing :[Off]
Regist Contact Check mode :[ Normal ]
Server Service Type :[Off ]
Regist Stop Control :[ Off ]
Regist Stop Response :[401] [403] [404] [ ] [ ] [ ] [ ] [ ]
--------------------------------------------------------------------------------
Selection: Tab, Down, Up, Right, Left, Character, Enter
Figure 34: SIP Common1 Form
Step 4 Configure Hitachi NT-SG SIP Module Connected with SIP Service Provider
Network
This step configures the Hitachi NT-SG SIP module connected with the SIP Service Provider
network, which starts with the Set Configuration Module Select screen (Figure 25).
• Select the SIP Module 2 item and press the enter key. The Type form will appear as
shown in Figure 35.
In these Application Notes, for the SIP Module 2 the Conf-1, User-1 and No.Plan1 were
configured. The Calling Table was not configured.
For the Configuration of the SIP module 2, specify the SIP entity information in the SIP Service
Provider network, the dialed number treatment manner, and the information to register with the
SIP Service Provider network.
• Press the space key until the Conf-1 type is displayed at the Configuration Type field.
• Press the enter key and then the Conf Menu screen will appear as shown in Figure 36.
• Select the SIP item by using the down and up arrow keys, and press the enter key. The
SIP Menu screen will appear as shown in Figure 37.