Use and Care Manual

Lowering: Lift up the head with a hand, unscrew the fastening knob counterclockwise

with the other hand, slowly lower the head to an appropriate height, and tighten the

knob clockwise. Rising: Lift up the head with a hand, unscrew the fastening knob

counterclockwise slowly with the other hand, rise up the head to a proper height,

and tighten the knob clockwise.

IV. Height Adjustment

When adjusting the pivoting angle, fix the guards with hands and reverse the head

of fan.

Note: Do not forcibly twist the fan, in order to avoid damaging the fan.

V. Pivoting Angle Adjustment

Press the “On/Off" button for three seconds, the screen will turn off and the fan is still

running. Press any button (execpt "On/Off” button), the screen will light up.

Remote does not have this feature.

VI. Screen-off Function

The fan will be turned off when there is no operation within 12 hours in order to save

energy.

VII. Auto Shut-off

Batteries should be installed before using the remote. It uses a 3 -volt button battery.

(1) Open the battery cover.

(2) Install a new battery, pay attention to the battery polarity (+ and -);

(3) Close the battery cover.

BATTERY INSTRUCTIONS (Fig.8)

The windings of the motor have a thermal-fuse that burns out and the fan switches

off and temperature of the motor is no longer going up. This makes sure the plastic

parts of the fan aren't subject to deformation and will not be burned by the overheat

if the motor is overheated for any unexpected reason.

OVERHEAT PROTECTION OF THE MOTOR

1. The remote must point to the receiving window of the fan box when it is used.

2. The remote can be effectively used within five meters and 30 degrees

from the fan.

3. Avoid direct sunlight on the receiving window, so as not to affect the receiver's

effect.

4. Remove the built-in battery when you will not be using the remote for a long

period of time.

HOW TO USE THE REMOTE CORRECTLY