User's Manual

P. 2 User Guide AS-1412
Transmitter Part Number and Serial Number of the Remote Car Starter Module
The boxes below contain information concerning your transmitter and Remote Car Starter.
We entered the part number of your transmitter for you. Should you need to order a new
transmitter, you will need to provide the transmitter part number which is printed below.
The second box contains the serial number of the Remote Car Starter. Please make sure
that the installer has entered the serial number in that box.
Transmitter Part Number: ASRA-2201G-100
The installer must use the space below to write the serial number of the Remote Car Starter
and the location of the valet switch (if installed):
Serial Number of the Remote Car Starter:
Location of the Valet Switch (if installed):
Introduction
This Module is a state-of-the-art remote car starter system. With many advanced function,
this product will satisfy any one of the user’s expectations from high-end commodity systems,
without neglecting the standard features commonly offered by entry-level starters.
Remote-starting Your Vehicle
Press the ΙΙ button for approx. 1 second. The parking lights will come on, informing you that
the unit has received your signal. Approx. 5 seconds later, the engine will start. The parking
lights will remain on during the pre-programmed run time.
If the vehicle doesn’t start the first time, the system will shut down, wait a few seconds, and
try to start the engine again. It will try to start the engine 3 times before giving up.
Vehicle Presets
Heater and Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation
for the next remote start. Settings for the blower motor (fan), front and rear, as well as
heated seats (if equipped) should not be left on
HIGH. It is recommended to leave the settings
on
LOW or MEDIUM instead.
Windshield Wipers, Radio and Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to
become energized while running under remote start. When leaving the vehicle you must
ensure that the windshield wiper and headlight switches are
OFF. Leaving the headlight
switch on on certain types of vehicles could cause them to remain on even after the remote
starter shuts down, resulting in a dead battery.
Driving Off
With the vehicle running under remote control, press button Ι to DISARM the module and to
UNLOCK the doors (if installed). Enter the vehicle and do the following:
• Turn the ignition key to the IGNITION ON (RUN) position.
• Press the brakes to disengage the remote starter unit.
You are now ready to drive off.
Caution: do not turn the key to the CRANK position with the engine running. This will cause
the starter motor to re-engage, unless your vehicle is equipped with the Start Kill / Anti-
Grind Feature (Optional).
Idle Mode
This feature allows the user to engage the remote starter to take over the vehicle while it is
already running with the key in the
IGNITION switch. The vehicle will keep running for the pre-
programmed run time, or until it is shut down by remote.