User's Manual
All warnings for correct installation are given in chapter 3.
All instructions for correct installation are given in "Part D" (related to the receiving unit).
5.3 Use
The use of industrial radio remote controls is strictly limited to skilled and properly trained
personnel.
All warnings for correct use are given in chapter 4.
All instructions for correct use are given in "Part C" (related to the transmitting unit).
Environmental working conditions are given in the following table.
Temperature Relative Humidity Air pressure
Use
of the
transmitting
unit
Class 4K4H
-20°C to +55°C
(-4°F to +130°F)
Class 4K4H
4% to 100%
Class 4K4H
70kPa to 106kPa
Use
of the receiving
unit
Class 4K4H
-20°C to +70°C
(-4°F to +158°F)
5.4 Radio remote control maintenance
The following instructions provide information to safely carry out routine and special
maintenance operations for the radio remote control.
They shall be completed by:
- instructions provided by the machine manufacturer
- directions provided by the installer of the radio remote control on the machine
- regulations regarding safety at work and accident prevention in force in the country where
the radio remote control is used.
All ne-tuning, checking and maintenance actions carried out on the radio remote control shall
be veried and recorded by the person in charge of carrying out maintenance on the machine.
Before any maintenance operation, disconnect power supply from the
receiving unit.
After each maintenance operation, always make sure that all commands sent
by the transmitting unit only activate the corresponding expected operations.
18
LIAIRE01-00
Radio remote control life cycle
AUTEC - Air series