Installation Manual

VEHICLE PREPARATION

1. Locate an accessory +12v power source with a good ground. These wires can be found at the ignition switch or fuse-box.

Power Source

• +12v when the key is in the ACC. and run positions.

• 0v when the key is OFF.

2. The mounting method and location will vary from vehicle to vehicle, the only focus of this manual is the installation of the AVXMTG13UHD

and related console accessories.

3. Generally, the best location for the video monitor is where the vehicle’s factory dome light is installed. The monitor should be located in such

a manner that it can be comfortably viewed by rear seat passengers.

NOTE: NEVER INSTALL THE MONITOR IN A PLACE WITHIN THE DRIVER’S VIEW. THIS IS NOT ONLY DANGEROUS, BUT IT IS ALSO ILLEGAL IN MANY

STATES.

4. Once the mounting location of the monitor has been determined, additional preparation work may be necessary, depending on the vehicle

structure and installation method. Some of the steps that may be required are:

a. Removal of the vehicle’s dome light.

b. Cutting an opening in the headliner to install the mounting bracket.