- 50-0301A

ManualsBrandsAudiovox ManualsAutomobile Accessories50-0301x-002 SERIES

INSTALLATION INSTRUCTIONS

FOR

50-0301x-002 SERIES 1181334

50-0301x-014 SERIES 1181332

50-0301x-019 SERIES 1181336

FORD EXPLORER / MERCURY MOUNTAINEER

VCP HOUSING

These instructions are intended for use only by experienced professionals in the automotive

customizing business. Special tools and equipment, as well as specialized handling and care

of product during installation, may be required. Before beginning this installation, carefully

read through the following instructions. Check for wiring or other componentry behind VCP

area before installing.

Materials/ Tools required for this installation:

1. #2 Phillips screwdriver 2. Powered screwdriver or drill with adapter

3. Awl or similar tool 4. Razor knife or similar

5. Audiovox VCP (AVP-7180 or equiv.)

Nov. 8, 1999

Printed in the U.S.A

INSTALLATION INSTRUCTION # 44-0040A

Summary of content (5 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR 50-0301x-002 SERIES 1181334 50-0301x-014 SERIES 1181332 50-0301x-019 SERIES 1181336 FORD EXPLORER / MERCURY MOUNTAINEER VCP HOUSING These instructions are intended for use only by experienced professionals in the automotive customizing business. Special tools and equipment, as well as specialized handling and care of product during installation, may be required. Before beginning this installation, carefully read through the following instructions.
PAGE 2
MATERIALS PROVIDED FOR INSTALLATION: ITEM Description 1 SCREW, # 8X 9/16" PWH 2 QTY 10 1 SCREW, # 8 X 3/4" PPH 2 2 3 VCP MOUNTING BRACKET 1 4 VCP HOUSING 1 5 FOAM TAPE, 3/4" X 3/4" X 14" 2 INSTALLATION INSTRUCTION # 44-0040A Nov. 8, 1999 Printed in the U.S.A.
PAGE 3
I. PREPARATION OF VEHICLE INTERIOR 1. Retract storage cover, remove from location and lay it in a safe place. See Figure 1. 2. Fold rear seat forward. FIGURE 1 3. Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to C-pillar. Down the C-pillar to the floor.
PAGE 4
5. Remove and discard (2) two screws from the left side of VCP. See Figure 4. FIGURE 4 6. Insert VCP into mounting bracket (item 3 pg 2) as shown in Figure 5. Route wiring through opening in VCP bracket. Connect all wiring to VCP per instructions included with video system. 7. Check function of all components. See operating instruction for video system operations check. For further assistance, refer to the video system manual for the technical support phone number listed for your area. 8.
PAGE 5
10. Install foam tape (item 5 pg 2) along each side of mounting bracket where lines were previously marked. See Figure 7. 11. Remove adhesive backing from Velcro tape along bottom of VCP bracket. See Figure 7. FIGURE 7 12. Install VCP housing (item 4 pg 2) and secure to mounting bracket using (2) two # 8 X 9/16" screws, removed in step 4. (item 1 pg 2). See Fig. 8. Make sure Velcro tape adheres to bottom of VCP housing. FIGURE 8 13. Trim floor mat, if applicable, to fit around VCP housing. See Figure 9.