A D 5~--~~ ---------Six Channel Ultimate Performance Line Driver Let the Good Sounds Sta•t! You have just purchased an ultimate-performance autosound product; the AudioControl Matrix Plus six channel line driver. The Matrix Plus allows you to utilize every last bit of performance and sound quality that you've always strived for from your vehicle's sound system. So find a nice dry spot (we can't recommend any near us), take a load off and spend a few moments reviewing this Enjoyment Manual.
FEATURES AND HIGHLIGHTS High-Voltage Line Driver The Matrix Plus is a pre-amp line driver that takes the input signal from up to three source units, increases it (up to 13 volts peak) and then delivers it downstream. No more low signal output voltages to allow noise into the rest of your performance car audio system. Six Channel Inputs & Outputs The Matrix Plus was designed for ultimate pre-amp flexibility.
Selectable Ground Isolation Avoiding ground loops and grounding-related noises are of paramount importance in any installation. For this reason we have provided a flexible scheme of isolating signal grounds and power grounds. Programmable Frequency Match (PFM) Subsonic Filter Many car audio systems truly push the limits of their subwoofer... without really knowing it. Tuned enclosures affect the roll-off of many speakers, yet lots of source material force the speakers to play lower than expected.
A GUIDED TOUR OF THE Matrix Plus The Outside 1. Inputs: The Matrix Plus will accept up to six channels of input signal which means it will work with source units that have six channels of output or it will accommodate three two-channel source units as in the case of multi-media. All of the inputs utilize a balanced differential input circuit, which can cancel noise that radiates into the signal path. 2.
0( 3 ) )0 ( 7 INPUTS ~~
7. 1, 2, & 5 Volt: These lights will tell you when the signal level is at 1 volt, 2 volts or 5 volts. You'll most likely want at least the 2-volt light to flicker, more if the rest of your components can handle it. Any AudioControl component that you connect after the Matrix Plus Line Driver won't mind the 5 volt light flickering. Go ahead. Light it up! 8.
12. Channel Linking: To link the Main input to Ch 2 and 3 outputs, move the main jumper to the (opposite) position to enable the linking function. Then move the jumpers for Ch 2 or 3 or both channels to the "Connected to Main" position. The "Connected to Main" LEDs will illuiminate when the three jumpers for each Ch 2 and/or Ch3 are set correctly. Please see video tutorials on our YouTube channel for more information. ~ a &' - !!.r-1 ~- I• •l•I ii 1 12~ ~----.-.-.
Signal-To-Noise: An Up and Coming Rock Group? Your systems signal-to-noise (SIN) ratio is the measurement between your audio signal level, which contains music, and your system's noise floor, which contains hiss, pops, buzzes, and whines. If you are listening to your buddies car audio systems and it has all of the above obnoxious sounds ... even when the music is playing, we call that LOW signal-tonoise.
Quick Install Guide Since some of you will want to install your Matrix Plus on your own we offer a few reminders in the following short section to speed up your installation. (I Phyc,ic~lly m011nt the J\,fotrix Plus in a location that keeps it away from soda spills, food crumbs, and curious fingers. 8 The Matrix Plus needs to be installed as close to the source unit as possible. Connect RCA cables from source unit to Matix Plus inputs.
Six-channel Source Unit Head units with separate front, rear and subwoofer outputs are easily accommodated with the Matrix Plus. Amplifier (Subwoofer) 0 - - - - - - - - - -:J ,_, Head Unit •• c:::::::::, • === (------): ---- 11."l' e '=' Subwoofer r~• /.-...a.,='~,bh___ / ...... 'e1• e e e ~ e e a ~ 8 ~ Jtl e '==- c:::::::::, 0 'et• ~ .. ., /._.-, e e ea Amplifier (Rear) I ' tr{ ~ ~i{:~5!;J~t!i-;~ :s e ...
Maximum SPL System The input channel linking feature allows the Matrix Plus to receive a two channel signal and produce six channels of output. Head Unit •• Amplifier (High Pass) Front output • === (---~--J: --- Qc::=::) ~· ~ (:::=~~----"' ~ ,'if',' ~ ' ~ .lt, ~ Subwoofer c::::::::> 0 'li• Amplifier (Subwoofer 1) ./._.,.,., 8 ;,;, i, !r.' [ : : - - - - - - - - - - ci), e/..-',"" e e e ~ ' rft/ . ..'t:"".::::-"'"·£•·- =--=.:::!i;:-~::-t':£~ ;s ~ •1.:._~,.,,.
The WARRANTY People are scared of warranties. Lots of fine print, lots of noncooperation, months of waiting around. Well, don't be scared of this warranty. It's designed to make you rave about us to your friends. It's a warranty that looks out for you and helps you resist the temptation to have your friend ''who's good with electronics" try to repair your AudioControl MATRIX PLUS.
Matrix Plus SPECIFICATIONS All specifications are measured at 14.4 VDC (standard automotive voltage) As technology advances, AudioControl reserves the right to continuously change our specifications, like our weather. Maximum input/output level. .......................................... 9 .5Vrms/ l 3V peak Frequency response...................................................... 10Hz-100 kHz;± 1dB Total harmonic distortion .................................................................. 0.
A D 5~--~~ ---------- Six Channel Ultimate Performance Line Driver Let the Good Sounds StaPt! You have just purchased an ultimate-performance autosound product; the AudioControl Matrix Plus six channel line driver. The Matrix Plus allows you to utilize every last bit of performance and sound quality that you've always strived for from your vehicle's sound system. So find a nice dry spot (we can't recommend any near us), take a load off and spend a few moments reviewing this Enjoyment Manual.
Matrix Plus SPECIFICATIONS All specifications are measured at 14.4 VDC (standard automotive voltage) As technology advances, AudioControl reserves the right to continuously change our specifications, like our weather. Maximum input/output level. .......................................... 9.5Vrms/ 13V peak Frequency response ...................................................... I 0Hz-1 00kHz;± 1dB Total harmonic distortion .................................................................. 0.