User's Manual

ManualsBrandsAudio-Technica ManualsPro AudioATW-3212N/C710 3000 Series Network Wireless Handheld Microphone System with ATW-C710 Capsule

Setting ATW-R3210

Setting the squelch level

Setting automatically

1. From the menu screen, turn the control dial, select [SQUELCH]

and then press the control dial.

2. Turn the control dial, select [AUTO] and then press the control

dial.

3. Turn the control dial, select [Normal], [High] or [Low] and then

press the control dial.

• You can select one from [Normal], [High] or [Low].

High: Prioritize the sound/voice quality.

Normal

Low: Prioritize the available range.

• If an error message is displayed, change the operating frequency. The

error indicates that the current frequency is already in use or that there is

excessive noise.

• Scan starts.

4. The scan result is shown. Press the control dial.

• The setting is complete.

Setting manually

1. From the menu screen, turn the control dial, select [SQUELCH]

and then press the control dial.

2. Turn the control dial, select [MANUAL] and then press the

control dial.

3. Turn the control dial to select the value you wish to set.

• The meter indicates the RF level.

• It can be set from levels 1 to 13.

• While the available range of the transmitter becomes wider as the

squelch level is lower, there may be cases when noises occur under the

influence of other radio waves. While the available range of the

transmitter becomes narrower as the squelch level is made higher, noises

are less likely to occur due to the less influence of other radio waves.

4. Press the control dial.

• The setting is complete.

Setting the system-related functions

Setting the lock

Set this function to prevent the receiver settings from being changed.

• The default setting is [Unlock].

1. From the menu screen, turn the control dial, select [UTILITIES]

and then press the control dial.

2. Turn the control dial, select [LOCK] and then press the control

dial.

3. Turn the control dial to select [Lock] or [Unlock], and then press

the control dial.

• The setting is complete.

Setting the antenna power

Set whether to turn power on or off to the antenna input terminals.

• The default setting is [OFF].

• If set to [ON], power is supplied to both antennas A and B.

1. From the menu screen, turn the control dial, select [UTILITIES]

and then press the control dial.

2. Turn the control dial, select [ANT PWR] and then press the

control dial.

3. Turn the control dial, select [ON] or [OFF] and then press the

control dial.

• The setting is complete.