User Manual

SWAM Woodwinds v2.9.0 - User Manual – rev. 1
11
Rand.Dyn
: Controls random modulation of dynamics and pitch.
Dyn.Pitch
: Amount of pitch modulation applied while changing the dynamics. Also controlled
by CC8 [Dyn.Pitch CC mapping is not possible for the Flutes].
Attack Sens.
: Changes the attack behavior, assigning it to: 1. Velocity (linear response, “hard”), 2.
Velocity (non-linear response, “soft”), or directly to Expression.
Harm.Struct
: Spectral characteristics of the instrument (balance between odd and even harmonics).
FallDown
: Clicking on this button triggers a fall. This effect is also assigned to Key Switch C1. It
is also possible to assign this to a CC (see OPTIONS page).
OverBlow
: Clicking this option triggers overblow on any quick changes to the dynamics. Also
assigned to Key Switch D1 (momentary) and D#1 (latch), as well as to the sustain pedal
(CC64).
SubHarm
: SubHarmonic intensity. Also controlled by CC20. [The SubHarm parameter is not
available for the Flutes].
Growl
: Growl intensity. Also controlled by CC21. For a “cleaner” sound, this should be set to zero.
Flutter T
: Flutter Tongue intensity, also controlled by CC23.
Breath N.
: Breath Noise intensity, also controlled by CC25.
Key Noise
: Key Noise intensity, also controlled by CC9.
Dyn.Harm
: Amount of harmonic and subharmonic modulation for attack and changes in
dynamics [Dyn.Harm parameter is not available for the Flutes].
Release
: Release Time on note-off.
Compressor
: Volume compression; controls the ratio between ff and pp levels.
Formant
: Changes the formants, thus the timbre of the instrument.
Modal Res
.: Changes the amount of lower harmonics persistence.
Transit.Time
: Selects the source of the note transition time control. The legato/portamento time
can be controlled by: velocity (default), CC (large values = long portamento time) or
CC inverted (small values = long portamento time).
Reset
: Resets the engine and reloads the default or previously saved parameters.
Options
: Opens Midi CC Remapper and Advanced Parameter Settings (see below).
Help & Credits
: Opens Help and Credits page.
* Default Load & Save paths are
: