Manual
WARNING
There may be electrical wiring located
between the roof and ceiling. Ensure
that power is properly disconnected at
the supply (mains and/or battery).
Failure to do so may result in personal
injury or death
TIP:
Always use crawl boards across
the roof
to
avoid
damage
POSITION UNIT ON ROOF
-
Remove
the
air
c
ond
i
t
i
on
e
r
from the
carton.
-
P
o
s
i
t
i
on
the unit
over
the
ga
s
ke
t
so
that
the
corners
of the
square hole
in the RV
roof
line up
with the
corners
of the
square
hole
und
e
r
n
e
a
t
h
the
air
c
ond
i
t
i
on
e
r
(Fig
6).
TIP:
Have one person inside
the RV
looking
t
h
r
ou
g
h
the
hole while
the other
is on
the roof
a
d
j
u
s
t
i
n
g
the
po
s
i
t
i
on
of the
unit.
The unit weights approximately 99
lbs (45kg). Ensure a two person lift or
use a mechanical hoist to avoid the
risk of injury.
-
DO NOT slide
the unit
on the roof,
t
h
i
s
may
damage
the
ga
s
ke
t
and
r
e
s
u
l
t
in
l
e
a
k
s
.
-
F
ou
r
M8
m
oun
t
i
n
g
holes on
the
chassis
und
e
r
n
e
a
t
h
the
air
c
ond
i
t
i
on
e
r
will
line up
with
the
corners
of the
square
roof
hole (Fig
7).
ATTACH ADAPTER TO UNIT
-
S
c
r
e
w
a
d
a
p
t
e
r
to the
underside
of unit with
the 4
screws provided (
t
h
i
s
s
t
e
p
can also
be
done before
the unit
is
po
s
i
t
i
on
e
d
on
the roof
but
be careful
not to
damage while
fitting)
-
The a
d
a
p
t
e
r
will
only
fit
one way, be
careful
to
ensure
a
d
a
p
t
e
r
is
po
s
i
t
i
on
e
d
c
o
rr
e
c
t
l
y
(Fig
8)
and avoid affixing back
to front.
CONNECT ELECTRICAL
SUPPLY
I
n
s
t
a
ll
a
t
i
on
m
u
s
t
conform
to
local wiring codes
and
r
e
g
u
l
a
t
i
on
s
or, in the
absence
of local
codes,
the
S
t
a
nd
a
r
d
on
R
e
c
r
e
a
t
i
on
a
l
Ve
h
i
c
l
e
s
,
NFPA 1192.
and
N
a
t
i
on
a
l
E
l
e
c
t
r
i
ca
l
Code
N
F
P
A
70.
-
C
onn
e
c
t
power supply
to
lead
from unit
- Note:
Brown (on
unit) to
Black
or
Red
– Hot
Blue (on
unit) to
Wh
i
t
e
–
Common
Y
e
ll
o
w
/
G
r
ee
n
(on
unit) to
Green
-
Ground
Fig 6- Position the unit over the roof gasket and set down gently.
Position the unit so the 4 mounting holes (circled) line up with the
corners.
Fig 8: Shows positioning of adapter to be attached to underside of unit. Ensure adapter
is mounted the correct way, screw holes will not line up if attached out of phase.
WARNING
Ensure that power is properly disconnected at the supply
(mains and/or battery). Failure to do so may result in
damage to the unit and personal injury or death.