User's Manual

Activating the Offender’s Monitoring Program
MEMS 3000 HomeStation & Transmitter Installation Guide
5-2
Performing a Range Test
1. First you need to verify that the phone LED (right) on the MEMS 3000
HomeStation is on.
2. Call the monitoring office personnel and request a range test. Once
initiated the following occurs:
• The Phone LED will flash indicating that the range test call is being
received and will return to its steady state once the range test call
has been completed.
• Once the range test has started, the middle LED blinks 3 times
(every 20 seconds). This is accompanied by 3 audible beeping
sounds. This indicates that the MEMS 3000 HomeStation is
receiving the appropriate transmission signal from the transmitting
tag
Note that the MEMS 3000 HomeStation is programmed to
automatically terminate the range test after approximately 15 minutes!
3. You can now escort the offender to the following locations:
• Locations that are the most distant from the MEMS 3000
HomeStation
• Locations behind large metal objects
• Locations where the offender may be located for long periods, for
example the living room, bedroom or toilet.
• Remote locations where the offender is also allowed to be, for
example the garage, cellar or back yard.