User's Manual

19
3 - Product coding
A
If, when the controller is powered
up for the first time, the display
shows the following message
it means that the controller has
not been configured yet.
The controller remain in stand-by
until the configuration code is set
correctly (see chapter 4.6 page 35).
9999
Conf
1
2
3
4
Alarm 2 type and function
N
Not active
0
Sensor break alarm / Loop Break Alarm
Absolute
2
active high
3
active low
Deviation
active high
4
active low
5
Band
active out
6
active in
7
Heater break
by CT [3]
active during ON output state
8
active during OFF output state
9
1
For alarm 3 type and function see page 34
Note
[3] Only with CT options.
Deviation
active high
Heater break
by CT [3]
4
active during ON output state
active low
Alarm 3 type and function
O
8
Disabled or used by Timer
0
5
Band
Sensor break alarm / Loop Break Alarm
1
Absolute
2
active high
active during OFF output state
3
active low
active out
9
6
active in
7