User manual

Chapter 1. Introduction

Note: Holes for ATEN Lok-U-Plug cable holders are located around the

outlets. See Securing the Cables, page 20, for further information.

No. Item Description

1 Power Outlets* 16 in total (14 x IEC 320 C13 + 2 x IEC 320 C19)

Bank 1-1: Outlet 1–8: 7 C13; 1 x C19

Bank 1-2: Outlet 9–16: 7 x C13; 1 x C19

2 Port and LED Panel The Port and LED panel contains:

 Readout Section and LEDs

 Environmental Sensor Ports

 LAN Port

 Door Sensor Port

 Reset Switch

Full details of this section are provided on

page 14.

3 Circuit Breaker

Pushbutton

As a safety measure, if there is an overcurrent

situation regarding the device’s power, the circuit

breakers will trip. Press the button to recover

normal operation.

Warning: See Resetting the Circuit Breaker,

page 64 for important information about resetting a

tripped circuit breaker.

4 Power Inlet The power cord that connects the unit to an AC

power source plugs into this socket.

 B models connect to a NEMA 6-20P source

 G models connect to an IEC 60320 C20 source

5 Outlet Status LEDs PE8216 (x 16) only.

These LEDs indicate outlet status.

Lights ORANGE for powered on.

Off for powered off.