ATD‐10512 7” Angle Grinder Instruction Manual Caution: Read this instruction manual before using this tool. Specifications Voltage: 120V/60Hz Amps: 11A No Load Speed: 7,800 RPM Max Accy Diameter: 7” Arbor Hole Diameter: 7/8” Safety Lock‐Off Switch: Yes Spindle Lock: Yes Spindle Thread: 5/8”‐11 Cord Length: 6.5’ Tool Weight: 7.
WARNING: This product contains chemicals including lead, known to the State of California to cause cancer, birth defects, or other reproductive harm. Wash hands after handling. WARNING: Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
c) Prevent unintentional starting. Ensure the switch is in the off‐position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energizing power tools that have the switch on invites accidents. d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. e) Do not overreach.
h) Wear personal protective equipment. Depending on application, use face shield, safety goggles or safety glasses. As appropriate, wear dust mask, hearing protectors, gloves and workshop apron capable of stopping small abrasive or work piece fragments. The eye protection must be capable of stopping flying debris generated by various operations. The eye protection must be capable of stopping flying debris generated by various operations.
c) Wheels must be used only for recommended applications. For example: do not grind with the side of cut‐off wheel. Abrasive cut‐off wheels are intended for peripheral grinding, side forces applied to these wheels may cause them to shatter. d) Always use undamaged wheel flanges that are of correct size and shape for your selected wheel. Proper wheel flanges support the wheel thus reducing the possibility of wheel breakage. Flanges for cut‐off wheels may be different from grinding wheel flanges.
Tool specifications: Model ATD‐10512 Voltage (V) 120 Frequency (Hz) Rated Current (A) No‐load speed (Min‐1) Disc dia. (mm) Spindle Thread 60 11 7800 7” 5/8” 1. Auxiliary handle 2. Spindle lock button 3. On/off switch 4. Square nut 5. Hex .screw 6. Grinding guard 7. Inner flange 8. Grinding disc 9. Outer flange 10. Spanner 2. Assembly Warning: Switch off the grinder and disconnect it from the power point. 1) The auxiliary handle (1) can be screwed to the left or the right of Gear Box.
Figure 1 Figure2 3) Fitting the grinding disc: (Figure 3 and Figure 4) A. Place the inner flange (7) over the spindle making sure the fit is tight B. Place the grinding disc(8) on the top of the inner flange ensuring the bore fits into the step of the flange C. Mount the concave recess side of the outer flange (9) over the spindle D. Press the spindle locking button (2) firm and ensure there is no movement in the spindle.
Lock the tool in the “on” position 1) When starting hold the tool firmly with both hands i.e. one hand on the motor housing and the other on the side auxiliary handle (1). 2) Start the tool by pressing trigger inwards, and then press the lock button at side to lock the tool at “on” condition. In this condition, the tool will operate continuously without pressing the trigger all the time (See figure 5) 3) Stop the tool by actuating the switch trigger again. 4.
