Network Router User Manual

EIA RS-232 Cabling 8-9

_ ______________________________________________________________________________________

Table 8-1. MPDM/M1* Option Settings

_ ________________________________

MPDM/M1* Option Settings

_ ________________________________

speed 56 Kbps or 64 Kbps

_ ________________________________

OFF-TRBK OFF

_ ________________________________

HDX-FDX OFF (FDX)

_ ________________________________

ASYN-SYNC SYNC

_ ________________________________

EXT-INT EXT

_ ________________________________

OFF-DISC OFF

_ ________________________________

OFF-KYBD OFF

_ ________________________________

OFF-PRTY OFF

_ ________________________________

O/EV-I/OD O/EV

_ ________________________________

OFF-DMLL OFF

_ ________________________________

OFF-MKBY MKBY

_ ________________________________

OFF-ANET ANET

_ ________________________________

OFF-SIGLS SIGLS

_ ________________________________

OFF-AANS AANS

_ ________________________________ 



SWITCH ADMINISTRATION

The only administration required at the switch is the translation of the new analog or DCP ports for

communication with the appropriate endpoints. For analog port translations, see the appropriate switch

documentation. For DCP port translations, see Chapter 9, DCP Cabling and Administration.

NOTE

Remember, if you are using MPDM/M1* data modules to convert RS-232 ports to DCP

mode 1 or DCP mode 3, these ports can only be used for incoming calls. Consequently, these

data modules must be administered as the ﬁrst members of an incoming hunt group on the

switch and the DCP ports should be administered as the remaining members of the hunt

group.