User's Manual
Table Of Contents
- Chapter 1
- Chapter 2
- Chapter 3
- BIOS Setup
- 3.1 BIOS Setup program
- 3.2 Main menu
- 3.3 Advanced menu
- 3.3.1 LVDS Configuration
- 3.3.2 PCH-FW Configuration
- 3.3.3 Trusted Computing
- 3.3.4 CPU Configuration
- 3.3.5 Graphics Configuration
- 3.3.6 PCI Express Configuration
- 3.3.7 AMT Configuration
- 3.3.8 CSM Configuration
- 3.3.9 Super IO Configuration
- 3.3.10 Serial Console Redirection
- 3.3.11 SATA And RST Configuration
- 3.3.12 Network Stack Configuration
- 3.3.13 USB Configuration
- 3.3.14 NVMe Configuration
- 3.3.15 Onboard Devices Configuration
- 3.3.16 EZ-Flash
- 3.3.17 APM Configuration
- 3.3.18 Watchdog Timer
- 3.3.19 Miscellaneous
- 3.4 Hardware Monitor menu
- 3.5 Security menu
- 3.6 Boot menu
- 3.7 Exit menu
- BIOS Setup
- Appendix
2-17
Chapter 2: Motherboard information
CAUTION! Never connect a 1394 cable to the USB connector. Doing so will
damage the motherboard.
NOTE: The USB cable is purchased separately.
4. USB 2.0 header (10-1 pin USB213)
This connector is for an USB 2.0 port. Connect the USB cable to this
connector. This USB connector complies with USB 2.0 specication that
supports up to 480 Mbps connection speed.
USB_213
NC
GND
USB_P1+
USB_P1-
USB+5V
GND
USB_P2+
USB_P2-
USB+5V
PIN 1
5. General purpose input/output header (10-pin GPIO_CON)
This connector is for a general purpose input/output module which allows you
to customize the digital signal input/output.
GPIO_CON
GPIO1
GPIO3
GPIO5
GPIO7
+3V
GPIO2
GPIO4
GPIO6
GPIO8
GND
PIN 1
Connector type
Header 2x5p, K9, 2.0mm pitch
Connector type
WAFER HD 2x5p, 2.0mm pitch, S/T