Owner manual
4-9ASUS V-Series P5G45
4. USB connectors (10-1 pin USB78; USB910; USB1112)
These connectors are for USB 2.0 ports. Connect the USB module cable to any
of these connectors, then install the module to a slot opening at the back of the
system chassis. These USB connectors comply with USB 2.0 specication that
supports up to 480 Mbps connection speed.
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
If your chassis supports front panel USB ports, you can attach a front panel
USB cable to these connectors. Connect the USB cable to ASUS Q-Connector
(USB, blue) rst, and then install the Q-Connector (USB) to the USB connector
onboard.
We highly recommend that you connect this
eSATA port to an eSATA external hard disk
drive using an
eSATA to eSATA cable
. DO
NOT connect the eSATA port to a SATA hard
disk drive using a eSATA to SATA cable.
The b u ndle d e SATA modu l e
allows you to add an eSATA port
on the back of your chassis. To
install the eSATA module, connect
the SATA cable co nnector to
any of the onboard SATA 1–6
connectors and then screw the
bracket to the chassis.
eSATA port
SATA cable connector
Bracket
eSATA cable connector
The USB module cable is purchased separately.