Quick Start Guide
ROG Chair SL200 Installation Guide
Package Contents
A
Installing the head pillow
C
Installing the Lumbar cushion
D
Assembling your chair
B
Put on the gloves before installation.
One by one, insert and push the wheels into the
base.
Insert the hydraulic lift cylinder into the center
hole of the base. Remove the red protective cap
on top if there was any.
Place the telescoping cover on the top of the
hydraulic lift cylinder.
Armrests normally do not
distinguish sides unless labeled
otherwise.
For models with armrest pre-
assembled, please skip this step.
Remove the pre-assembled bolts and washers
(
1
&
3
). Place the 4 large washers (
1
)
between the armrest mounting bar (
2
) and the
seat base. Hold the armrest in place, then insert
and tighten all 4 bolts (
3
). Use the hex key to
tighten them all, and repeat on the other side.
Use the hex key to remove the pre-assembled
bolts and washers from the backrest.
Remove the protective foam covers from the
brackets of the seat base. Then position the
backrest carefully between the brackets. Insert
and attach the 4 bolts (2 on each side) you
removed in step 5 by hand rst. Then use the hex
key to tighten them. Start with the two bolts on
the top of each side, then the bottom two.
ET14663 / First Edition / August 2018
1.
Backrest
6.
Wheels
11.
Hydraulic lift cylinder
2.
Seat base
7.
Side covers with bolts
12.
Telescoping cover
3.
Head pillow
8.
Pillow strip connector
13.
Hex Key
4.
Lumbar cushion
9.
Control unit
14.
Spare bolt
5.
Wheel base
10.
Gloves
Note: The illustrations are for reference only and may dier from your actual
chair in appearance and features.
Install the side covers and tighten the bolts. (The
covers are marked “L” for the left side and “R” for the
right on the inside.)
Now ip the chair over, facing down. Then remove
the 4 pre-mounted bolts from the underside with
washers.
Place the control unit straight and tighten
the bolts. Ensure that the “Front” arrow
pointing to the front of the chair and the
control lever on the same side of the recline
lever.
10. Insert top of the hydraulic lift cylinder into the
mounting hole on the control unit, and then turn
the chair over in upright position. (Two-person
handling required for your safety)
Pull the elastic through the opening on
the backrest.
Pull the elastic through the opening
on the other side.
Put the elastic around the top of the
backrest and adjust the height accordingly.
Push the two bottom straps through the gap
between the seat bottom and backrest to the
back of the chair.
* Some models come with Lumbar cushion
without straps.
Put the two top straps through the openings on the backrest. Pull the
bottom straps at the back up and buckle them together. Adjust the
height of the Lumbar pillow by pulling the two straps up and down.
For models do not have openings on backrest, mount straps on
shoulders of the backrest. (See the alternative mounting method
above)
Alternative mounting
Pillow for lumber pillow straps
Hook the elastic with the connector
on one side.
Hook the elastic with the connector
on the other side.
Method A
Method B