Manual

1-31-3

1-3

ASUS S-pressoASUS S-presso

ASUS S-presso

1.1.31.1.3

1.1.3

BIOS/Jumper settingsBIOS/Jumper settings

BIOS/Jumper settings

Make sure you make the following BIOS and jumper settings before

installing Instant On to your hard disk drive.

IDE hard disk drive and IDE optical driveIDE hard disk drive and IDE optical drive

IDE hard disk drive and IDE optical drive

1. Set the HDD jumper to

MASTERMASTER

MASTER.

2. Set the ODD jumper to

MASTERMASTER

MASTER.

3. Make the following BIOS settings:

• Set your hard disk drive as Primary IDE Master.

• Set your optical drive as Secondary IDE Master.

Instant On

does not

support Serial ATA optical drives.

System Time [11:10:19]

System Date [Tue, 01/10/2005]

Language [English]

Primary IDE Master [Maxtor 6Y080L0]

Primary IDE Slave [Not Detected]

Secondary IDE Master [ASUS CDS520/]

Secondary IDE Slave [Not Detected]

Third IDE Master [Not Detected]

Fourth IDE Master [Not Detected]

IDE Configuration

System Information

IDE Configuration

Onboard IDE Operate Mode [Enhanced Mode]

4. In the IDE Configuration sub-menu, set the

Onboard IDEOnboard IDE

Onboard IDE

Operate ModeOperate Mode

Operate Mode item to [Enhanced Mode].

Make sure that your optical drive is set as the 1st Boot Device.