User Guide
Table Of Contents
- 目录
- 使用注意事项
- 用电安全
- 关于本用户手册
- 第一章:系统导览
- 第二章:硬件安装
- 第三章:高级安装
- 第四章:主板信息
- 第五章:BIOS 程序设置
- 5.1 管理、更新您的 BIOS 程序
- 5.2 BIOS 程序设置
- 5.3 主菜单(Main)
- 5.4 高级菜单(Advanced menu)
- 5.4.1 ACPI 设置
- 5.4.2 Smart Setting(智能设置)
- 5.4.3 NCT6779D Super IO 设置
- 5.4.4 内置 LAN I210 IO 设置
- 5.4.5 串口控制面板重新定向(Serial Port Console Redirection)
- 5.4.6 APM 设置
- 5.4.7 PCI 子系统设置(PCI Subsystem Settings)
- 5.4.8 局域网堆栈设置(Network Stack Configuration)
- 5.4.9 CSM 设置
- 5.4.10 可信任运算设置(Trusted Computing)
- 5.4.11 USB 设置(USB Configuration)
- 5.4.12 iSCSI 设置
- 5.5 IntelRCSetup 菜单
- 5.6 服务器管理菜单(Server Mgmt menu)
- 5.7 事件记录菜单(Event Logs menu)
- 5.8 监控菜单(Monitor menu)
- 5.9 安全性菜单(Security menu)
- 5.10 启动菜单(Boot menu)
- 5.11 工具菜单(Tool menu)
- 5.12 退出 BIOS 程序(Exit)
- 第六章:磁盘阵列设置
- 第七章:安装驱动程序
- 附录
華碩 RS720Q-E8-RS12 用戶手冊
5-31
C/A Parity Enable [Auto]
開啟或關閉 DDR4 命令地址校驗。設置值有:[Auto] [Disabled]
[Enabled]。
Memory Topology
顯示有關 DIMM 內存拓樸結構的完整信息。
Set Throttling Mode [Disabled]
設置值有:[Disabled] [OLTT] [CLTT]。
OLLT Peak BW [xxx]
設置 OLTT 最高帶寬。設置值為百分比,且有效偏移值為 25-100。
DIMM Tem Stat [xx]
選擇 DIMMTEMPSTAT 作為 temp_mid 或 tem_hi。
Memory Power Savings Mode [Auto]
本項為用來設置 CKE 和其他相關內存省能功能。設置值有:[Auto]
[Disabled] [APD On] [User Defined] [Reserve] [Reserved]。
Memory Power Savings Advanced Options
CK in SR [Auto]
設置值有:[Auto] [Driven] [Tri-State] [Pulled Low] Pulled High]。
MDLL Off [Auto]
若設為開啟,可在 SR 時關閉 MDLL。設置值有:[Auto] [Disabled]
[Enabled]。
Memory Thermal
用來進行散熱設置。