User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- 2.1 Chassis cover
- 2.2 Air ducts
- 2.3 Central Processing Unit (CPU)
- 2.4 System memory
- 2.5 (optional) Front bezel
- 2.6 Storage devices
- 2.7 Expansion slot
- 2.7.1 Installing an expansion card to riser card bracket 1 (for standard model)
- 2.7.2 Installing an expansion card to riser card bracket 2 and 3 (for standard model)
- 2.7.3 Installing a GPU card to riser card bracket 1 (for GPU model)
- 2.7.4 Installing a GPU card to riser card bracket 2 and 3 (for GPU model)
- 2.7.5 Installing an expansion card to riser bracket 4
- 2.7.6 Installing an ethernet expansion card to riser bracket 4
- 2.7.7 Replacing an HBA/RAID expansion card to riser bracket 4
- 2.7.8 Installing the Cache Vault Power Module
- 2.7.9 Installing an OCP 3.0 card
- 2.7.10 Installing an M.2 (NGFF) card
- 2.7.11 Configuring an expansion card
- 2.8 Cable connections
- 2.9 Backplane cabling
- 2.10 Storage device configuration and cabling
- 2.11 Removable/optional components
- 2.12 Rail Kit Options
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 Redfish Host Interface Settings
- 4.5.3 AMD CBS
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 CPU Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 Network Stack Configuration
- 4.5.10 NVMe Configuration
- 4.5.11 SATA Configuration
- 4.5.12 APM Configuration
- 4.5.13 AMD Mem Configuration Status
- 4.5.14 T1s Auth
- 4.5.15 Driver Health
- 4.5.16 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
Chapter 2: Hardware Information
2-20
3. Push the left side of the front bezel towards the left USB panel.
4. Make sure the two (2) left notches on the front bezel are aligned with the notch holes
on the left USB panel, then push and attach the front bezel to the left USB panel.
Make sure the bezel release latch is in the unlock state (pushed to the right) before
attaching the front bezel to the left USB panel.