User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- 2.1 Chassis cover
- 2.2 Air ducts
- 2.3 Central Processing Unit (CPU)
- 2.4 System memory
- 2.5 (optional) Front bezel
- 2.6 Storage devices
- 2.7 Expansion slot
- 2.7.1 Installing an expansion card to riser card bracket 1 (for standard model)
- 2.7.2 Installing an expansion card to riser card bracket 2 and 3 (for standard model)
- 2.7.3 Installing a GPU card to riser card bracket 1 (for GPU model)
- 2.7.4 Installing a GPU card to riser card bracket 2 and 3 (for GPU model)
- 2.7.5 Installing an expansion card to riser bracket 4
- 2.7.6 Installing an ethernet expansion card to riser bracket 4
- 2.7.7 Replacing an HBA/RAID expansion card to riser bracket 4
- 2.7.8 Installing the Cache Vault Power Module
- 2.7.9 Installing an OCP 3.0 card
- 2.7.10 Installing an M.2 (NGFF) card
- 2.7.11 Configuring an expansion card
- 2.8 Cable connections
- 2.9 Backplane cabling
- 2.10 Storage device configuration and cabling
- 2.11 Removable/optional components
- 2.12 Rail Kit Options
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 Redfish Host Interface Settings
- 4.5.3 AMD CBS
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 CPU Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 Network Stack Configuration
- 4.5.10 NVMe Configuration
- 4.5.11 SATA Configuration
- 4.5.12 APM Configuration
- 4.5.13 AMD Mem Configuration Status
- 4.5.14 T1s Auth
- 4.5.15 Driver Health
- 4.5.16 Third-party UEFI driver configurations
- 4.6 Chipset menu
- 4.7 Security menu
- 4.8 Boot menu
- 4.9 Tool menu
- 4.10 Event Logs menu
- 4.11 Server Mgmt menu
- 4.12 Exit menu
- Chapter 5: Driver Installation
- Appendix
ASUS RS720A-E12 Series
3-19
12. Micro SD card slot (MSD1)
Your motherboard supports SD Memory Card v2.00 (SDHC) / v3.00 (SDXC).
Disconnect all power (including redundant PSUs) from the existing system before you add
or remove a Memory Card, then reboot the system to access the Memory Card.
• Storage Device Activity LED connector (HDLED)
This connector allows you to connect the Storage Device Activity LED. The Storage
Device Activity LED lights up or blinks when data is read from or written to the storage
device or storage device add-on card.
13. OCP Side connector (OCP_SIDE1)
This connector connects the OCP 3.0 Riser card sideband signals to the motherboard