User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- 2.1 Chassis cover
- 2.2 Central Processing Unit (CPU)
- 2.3 System memory
- 2.4 Storage devices
- 2.5 Expansion slot
- 2.5.1 Installing an expansion card to riser card bracket 1
- 2.5.2 Installing an expansion card to riser card bracket 2
- 2.5.3 Installing an expansion card to riser card bracket 3 (for model without rear bay only)
- 2.5.4 Installing an expansion card to riser card bracket 4
- 2.5.5 Replacing the ASUS PIKE II card
- 2.5.6 Installing an ASUS PCIE-NVME4-OCuLink card
- 2.5.7 Replacing the ASUS PCIE-NVME2-OCuLink card (for model with rear bay only)
- 2.5.8 Configuring an expansion card
- 2.5.9 Installing Mezzanine cards
- 2.5.10 Installing M.2 (NGFF) cards
- 2.6 Cable connections
- 2.7 SATA/SAS backplane cabling
- 2.8 Removable/optional components
- Chapter 3: Installation Options
- Chapter 4: Motherboard Information
- Chapter 5: BIOS Setup
- 5.1 Managing and updating your BIOS
- 5.2 BIOS setup program
- 5.3 Main menu
- 5.4 Performance Tuning menu
- 5.5 Advanced menu
- 5.5.1 Trusted Computing
- 5.5.2 ACPI Settings
- 5.5.3 Smart Settings
- 5.5.4 Super IO Configuration
- 5.5.5 Serial Port Console Redirection
- 5.5.6 Onboard LAN Configuration
- 5.5.7 APM
- 5.5.8 PCI Subsystem Settings
- 5.5.9 USB Configuration
- 5.5.10 CSM Configuration
- 5.5.11 NVMe Configuration
- 5.5.12 Offboard SATA Controller Configuration
- 5.5.13 Network Stack Configuration
- 5.5.14 iSCSI Configuration
- 5.6 Platform Configuration menu
- 5.7 Socket Configuration menu
- 5.8 Event Logs menu
- 5.9 Server Mgmt menu
- 5.10 Security menu
- 5.11 Boot menu
- 5.12 Tool menu
- 5.13 Save & Exit menu
- Chapter 6: RAID Configuration
- Chapter 7: Driver Installation
- Appendix
2-17
ASUS RS720-E9 Series
To install a 3.5” hot-swap storage device to the front panel:
1. Push the spring lock to the right (A)
then pull the tray lever outward (B)
to release the tray. The tray ejects
slightly after you pull out the lever.
2. Firmly hold the tray lever and pull the
tray out of the bay.
3. Placethetrayonaatandstablesurface.
4. Prepare the 3.5” hot-swap storage device and the bundled set of screws.
Spring lock
Tray lever