User Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Hardware Information
- 2.1 Chassis cover
- 2.2 Air duct(s)
- 2.3 Central Processing Unit (CPU)
- 2.4 System memory
- 2.5 (optional) Front bezel
- 2.6 Storage devices
- 2.7 Expansion slots
- 2.7.1 Installing an expansion card to the PCIe riser card bracket
- 2.7.2 Installing an OCP card
- 2.7.3 Installing an expansion card to the butterfly riser card bracket
- 2.7.4 Installing an ethernet expansion card to the butterfly riser card bracket
- 2.7.5 Installing an HBA/RAID card to the butterfly riser card bracket
- 2.7.6 Installing the Cache Vault Power Module
- 2.7.7 Installing an M.2 (NGFF) card
- 2.7.8 Configuring an expansion card
- 2.8 Cable connections
- 2.9 Backplane cabling
- 2.10 Storage device configuration and cabling
- 2.11 Removable/optional components
- 2.12 Rail Kit Options
- Chapter 3: Motherboard Information
- Chapter 4: BIOS Setup
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Performance Tuning menu
- 4.5 Advanced menu
- 4.5.1 Trusted Computing
- 4.5.2 ACPI Settings
- 4.5.3 Redfish Host Interface Settings
- 4.5.4 Onboard LAN Configuration
- 4.5.5 Serial Port Console Redirection
- 4.5.6 SIO Configuration
- 4.5.7 PCI Subsystem Settings
- 4.5.8 USB Configuration
- 4.5.9 Network Stack Configuration
- 4.5.10 NVMe Configuration
- 4.5.11 APM Configuration
- 4.5.12 Tls Auth Configuration
- 4.5.13 Intel(R) Virtual RAID on CPU
- 4.6 Platform Configuration menu
- 4.7 Socket Configuration menu
- 4.8 Security menu
- 4.9 Boot menu
- 4.10 Tool menu
- 4.11 Event Logs menu
- 4.12 Server Mgmt menu
- 4.13 Exit menu
- Chapter 5: Driver Installation
- Appendix
Chapter 3: Motherboard Information
3-22
13. Micro SD card slot (MSD1)
Your motherboard supports SD Memory Card v2.00 (SDHC) / v3.00 (SDXC).
Disconnect all power (including redundant PSUs) from the existing system before you add
or remove a Memory Card, then reboot the system to access the Memory Card.
14. VPP_I2C connector (10-1 pin VPP_I2C1)
The VPP_I2C connector is used for the storage backplane with sensor readings.