User Manual

6-4 Chapter 6: RAID conguration
3. The utility main window appears. Use the arrow keys to select an option from
the
Management Menu
, then press <Enter>. Refer to the Management Menu
descriptions on the next page.
At the bottom of the screen is the legend box. The keys on the legend box
allow you to navigate through the setup menu options or execute commands.
The keys on the legend box vary according to the menu level.
6.2 LSISoftwareRAIDCongurationUtility
The LSI Software RAID Conguration Utility allows you to create RAID 0,
RAID 1, or RAID 10 set(s) from SATA hard disk drives connected to the SATA
connectors supported by the motherboard Southbridge chip.
To enter the LSI Software RAID Conguration Utility:
1. Turn on the system after installing all the SATA hard disk drives.
2. During POST, the LSI Software RAID Conguration Utility automatically
detects the installed SATA hard disk drives and displays any existing RAID
set(s). Press <Ctrl> + <M> to enter the utility.
The LSI Software RAID Conguration Utitlity auto congures to RAID 1
when the SATA to RAID Mode is enabled.
The RAID setup screens shown in this section are for reference only and
may not exactly match the items on your screen due to the controller
version difference.
When you create RAID sets with the LSI Software RAID conguration utility,
the boot priority of the SATA optical drive has to be manually adjusted.
Otherwise, the system will not boot from the connected SATA ODD.
LSI Logic Software RAID Conguration Utility Ver A.51 Aug 13, 2007
Use Cursor Keys to Navigate Between Items And Press Enter To Select An Option
Management Menu
Congure
Initialize
Objects
Rebuild
Check Consistency
Congure VD(s)
LSI MegaRAID Software RAID BIOS Version A.01 08131852R
LSI SATA RAID Found at PCI Bus No: Dev No:1F
Device present at Port 0 HDS722512VLSA80 117800MB
Device present at Port 1 HDS722512VLSA80 117800MB
Press Ctrl-M or Enter to run LSI Software RAID Setup Utility.