User Manual

Industrial motherboard

Device reset time-out

Allows you to select time-out value for USB mass storage device Start Unit

command.

Configuration options: [10 sec] [20 sec] [30 sec] [40 sec]

Device power-up delay

Allows you to select maximum time the device will take before it properly

reports itself to the Host Controller. [Auto] uses the default value, for a Root

port, it is 100 ms. For a Hub port, the delay is taken from Hub descriptor.

Configuration options: [Auto] [Manual]

NOTE: The following item appears only when Device power-up delay

is set to [Manual].

Device power-up delay in seconds

Allows you to set the device power-up delay in seconds. Use the <+> or <->

to adjust the value. The values range from 1 to 40.

USB3