User’s Manual
Table Of Contents
- Safety information
- Chapter 1: Product Introduction
- Chapter 2: Basic Installation
- 2.1 Building your PC system
- 2.1.1 Installing the CPU and heatsink
- 2.1.2 DIMM installation
- 2.1.3 M.2 installation
- 2.1.4 Additional cooling kit installation
- 2.1.5 Motherboard installation
- 2.1.6 ATX power connection
- 2.1.7 SATA device connection
- 2.1.8 SlimSAS connection
- 2.1.9 Front I/O connector
- 2.1.10 Expansion card installation
- 2.1.11 M.2 Wi-Fi module and antenna installation
- 2.2 BIOS update utility
- 2.3 Motherboard rear and audio connections
- 2.4 Starting up for the first time
- 2.5 Turning off the computer
- 2.1 Building your PC system
- Chapter 3: BIOS Support
- Appendix
1-16
Chapter 1: Product Introduction
Chapter 1
14. BMC Thermal Sensor header
The BMC Thermal Sensor header allows you to connect a sensor to monitor the
temperature of the devices and the critical components inside the motherboard
through BMC. Connecting the T sensor cables and setting BMC_SW to enabled will
allow you to view the sensor readings in both the BIOS and on the web UI.
15. COM Port connector
The COM (Serial) Port connector allows you to connect a COM port module. Connect
the COM port module cable to this connector, then install the module to a slot opening
on the system chassis.
The COM port module is purchased separately.