Configuration Guide
Table Of Contents
- About this guide
- Intel® RAID Configuration
- 1. RAID definitions
- 2. Installing storage devices
- 3. Creating a SATA RAID set in UEFI BIOS
- 4. Creating a SATA RAID set in BIOS
- 5. Creating an NVMe RAID set with onboard M.2 modules in UEFI BIOS
- 6. Creating an NVMe RAID set with onboard M.2/PCIe storage modules in BIOS
- 7. Creating an NVMe RAID set with expansion M.2 card in UEFI BIOS
- 8. Creating an NVMe RAID set with expansion M.2 card in BIOS
- 9. Installing the RAID controller driver during Windows® 10 or Windows® 11 OS installation
Intel
®
RAID Configuration Guide
1-11
4. Creating a SATA RAID set in BIOS
Some BIOS options may differ, but the steps remain the same.
1. Install the VROC key to the motherboard.
Refer to your motherboard’s user guide for the location of the VROC Key slot.
2. Power on your board and enter the BIOS Setup during POST.
Refer to Chapter 3 in your motherboard’s user guide for details on entering and navigating
through the BIOS Setup.
3. Go to Platform Config > PCH Configuration > PCH Storage Configuration >
Controller SATA and RST Configuration.
4. Set SATA Mode Selection to [RAID].
5. Save your changes and exit the BIOS Setup, then enter the BIOS Setup again.
6. Go to Advanced > Intel(R) VROC SATA Controller to display the Intel
®
VROC SATA
controller menu.