User Manual
Table Of Contents
- 1. UEFIとは
- 2. BIOS Setup Utility
- 3. BIOSの管理と更新
- 4. メニュー画面
- 5. Main
- 6. Ai Tweaker
- 7. Advanced
- 7.1 Platform Misc Configuration
- 7.2 CPU Configuration
- 7.3 System Agent (SA) Configuration
- 7.4 PCH Configuration
- 7.5 PCH Storage Configuration
- 7.6 PCH-FW Configuration
- 7.7 AMT Configuration
- 7.8 Redfish Host Interface Settings
- 7.9 Serial Port Console Redirection
- 7.10 Intel TXT Information
- 7.11 PCI Subsystem Settings
- 7.12 USB Configuration
- 7.15 HDD/SSD SMART Information
- 7.13 Network Stack Configuration
- 7.14 NVMe Configuration
- 7.16 APM Configuration
- 7.17 Onboard Devices Configuration
- 7.18 Intel(R) Rapid Storage Technology
- 8. Monitor
- 9. Boot
- 10. Tool
- 11. Server Mgmt
- 12. MEBx
- 13. Exit
20
Pro WS W680M-ACE SE BIOS ガイド
Early ReadMPR Timing Centering 2D
設 定オプション: [Auto] [Enabled] [Disabled]
Read MPR Training
設 定オプション: [Auto] [Enabled] [Disabled]
Receive Enable Training
設 定オプション: [Auto] [Enabled] [Disabled]
Jedec Write Leveling
設 定オプション: [Auto] [Enabled] [Disabled]
Early Write Timing Centering 2D
設 定オプション: [Auto] [Disabled] [Enabled]
Early Read Timing Centering 2D
設 定オプション: [Auto] [Disabled] [Enabled]
Write Timing Centering 1D
設 定オプション: [Disabled] [Enabled]
Write Voltage Centering 1D
設 定オプション: [Auto] [Disabled] [Enabled]
Read Timing Centering 1D
設 定オプション: [Auto] [Disabled] [Enabled]
Read Timing Centering with JR
設 定オプション: [Auto] [Disabled] [Enabled]
Dimm ODT Training*
設 定オプション: [Auto] [Disabled] [Enabled]
Max RTT_WR
パワートレーニングにおけるRTT_WRの最大値に上限を設定することができ
ます。
設 定オプション: [ODT OFF] [120 Ohms]
DIMM RON Training*
設 定オプション: [Auto] [Disabled] [Enabled]
Write Drive Strength/Equalization 2D*
設 定オプション: [Auto] [Disabled] [Enabled]
Write Slew Rate Training*
設 定オプション: [Auto] [Disabled] [Enabled]
Read ODT Training*
設 定オプション: [Auto] [Disabled] [Enabled]
Comp Optimization Traning
設 定オプション: [Auto] [Disabled] [Enabled]
Read Equalization Training*
設 定オプション: [Auto] [Disabled] [Enabled]
Read Amplier Training*
設 定オプション: [Auto] [Disabled] [Enabled]
Write Timing Centering 2D
設 定オプション: [Auto] [Disabled] [Enabled]
Read Timing Centering 2D
設 定オプション: [Auto] [Disabled] [Enabled]
Command Voltage Centering
設 定オプション: [Auto] [Disabled] [Enabled]