Manual

7-3
ASUS PCI-DA2200 User’s Manual
Support for 3 Disks or More (MS-DOS v5.0 or Above)
For MS-DOS version below 5.0, only supports up to 2 disks, don't set
this option to "Yes" on such versions DOS system.
Support for NOT-ZERO SCSI LUN
Set this option to "Yes", if you want the BIOS to support all SCSI
Target LUNs, 0 to 7.
Configure BIOS Devices
Logical Device SCSI ID #0 #1 #2 #3 #4 #5 #6 #7
Scanned By BIOS Yes Yes Yes Yes Yes Yes Yes Yes
Logical Device SCSI ID #8 #9 #10 #11 #12 #13 #14 #15
Scanned By BIOS Yes Yes Yes Yes Yes Yes Yes Yes
If this option is selected, a status list of SCSI devices scanned by BIOS
at BIOS initialization will appear. If a SCSI device is not scanned by
BIOS, then it will not be installed by BIOS.
7.1.2. Configure Card
ISA Emulation Mode IO Port Address Disabled
Disk Access Delay on Power-up (Sec) 15
ISA Emulation Mode
If you are going to use ASUS PCI-DA2200 device driver distributed
by Infortrend, you MUST set the IO port address to "Disabled". You
can select an IO Port address from a list by pressing [Enter].
7.1.3. Configure SCSI
Configure RAID
Configuration Color/Monochrome
Configure BIOS
Configure Card
Configure SCSI
Reset to Defaults
SCSI Channel 1
SCSI Channel 0