User's Manual
Table Of Contents
- Safety information
- Chapter 1
- Product introduction
- Chapter 2
- BIOS information
- 2.1 Managing and updating your BIOS
- 2.2 BIOS setup program
- 2.3 Main menu
- 2.4 Ai Tweaker menu
- 2.4.1 CPU bus speed : DRAM speed ratio mode [Auto]
- 2.4.2 Memory Frequency [Auto]
- 2.4.3 EPU Power Saving Mode [Disabled]
- 2.4.4 GPU Boost [OK]
- 2.4.5 DRAM Timing Control
- 2.4.6 CPU Power Management
- 2.4.7 Offset Mode Sign [+]
- 2.4.8 DRAM Voltage [Auto]
- 2.4.9 VCCIO Voltage [Auto]
- 2.4.10 VCCSA Voltage [Auto]
- 2.4.11 CPU PLL Voltage [Auto]
- 2.4.12 PCH Voltage [Auto]
- 2.4.13 Load-Line Calibration [Auto]
- 2.5 Advanced menu
- 2.6 Monitor menu
- 2.7 Boot menu
- 2.7.1 Bootup NumLock State [On]
- 2.7.2 Full Screen Logo [Enabled]
- 2.7.3 Wait for ‘F1’ If Error [Enabled]
- 2.7.4 Option ROM Messages [Force BIOS]
- 2.7.5 Setup Mode [EZ Mode]
- 2.7.6 UEFI/Legacy Boot [Enabled both UEFI and Legacy]
- 2.7.7 PCI ROM Priority [Legacy ROM]
- 2.7.8 Boot Option Priorities
- 2.7.9 Boot Override
- 2.8 Tools menu
- 2.9 Exit menu
- Appendices
Chapter 2: BIOS information 2-11
Administrator Password
If you have set an administrator password, we recommend that you enter the administrator
password for accessing the system. Otherwise, you might be able to see or change only
selected elds in the BIOS setup program.
To set an administrator password:
1. Select the
Administrator Password item and press <Enter>.
2. From the
Create New Password box, key in a password, then press <Enter>.
3. Conrm the password when prompted.
To change an administrator password:
1. Select the
Administrator Password item and press <Enter>.
2. From the
Enter Current Password box, key in the current password, then press <Enter>.
3. From the
Create New Password box, key in a new password, then press <Enter>.
4. Conrm the password when prompted.
To clear the administrator password, follow the same steps as in changing an administrator
password, but press <Enter> when prompted to create/conrm the password. After you clear
the password, the Administrator Password item on top of the screen shows Not Installed.
User Password
If you have set a user password, you must enter the user password for accessing the system.
The User Password item on top of the screen shows the default Not Installed. After you set
a password, this item shows Installed.
To set a user password:
1. Select the
User Password item and press <Enter>.
2. From the
Create New Password box, key in a password, then press <Enter>.
3. Conrm the password when prompted.
To change a user password:
1. Select the
User Password item and press <Enter>.
2. From the
Enter Current Password box, key in the current password, then press <Enter>.
3. From the
Create New Password box, key in a new password, then press <Enter>.
4. Conrm the password when prompted.
To clear the user password, follow the same steps as in changing a user password, but press
<Enter> when prompted to create/conrm the password. After you clear the password, the
User Password item on top of the screen shows Not Installed.