Owner's manual

ASUS P5B-Plus Series
2-27
2.7.2 Internal connectors
1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector is for the provided oppy disk drive (FDD) signal cable. Insert
one end of the cable to this connector, then connect the other end to the
signal connector at the back of the oppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection when
using a FDD cable with a covered Pin 5.
P5B-PLUS
®
P5B-PLUS Floppy disk drive connector
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
FLOPPY
2. JMicron JMB363
®
Serial ATA RAID connector (7-pin SATA_RAID)
This connector is for a Serial ATA signal cable. This connector supports a
Serial ATA hard disk drive, which you can combine with an external Serial
ATA hard disk drive to congure for RAID via the onboard Serial ATA RAID
controller.
The JMicron JMB363 controller item in the BIOS is set to [IDE] by default.
Before creating a RAID set using Serial ATA hard disks, make sure that you
have connected the Serial ATA signal cables and installed Serial ATA hard disk
drives; otherwise, you CANNOT enter the JMicron
®
JMB363 RAID utility and
SATA BIOS setup during POST.
P5B-PLUS
®
P5B-PLUS SATA_RAID connector
SATA_RAID
GND RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND