User guide

Chapter 2: BIOS setup 2-13
MemClk Tristate C3/ATLVID [Disabled]
Enables or disables the MemClk Tristate C3/ALTVID.
Conguration options: [Disabled] [Enabled]
Memory Hole Remapping [Enabled]
Allows you to enable or disable memory remapping around memory hole.
Conguration options: [Disabled] [Enabled]
DCT Unganged Mode [Auto]
DCT Unganged Mode [Auto]
Allows you to select unganged DRAM mode (64-bit width).
Conguration options: [Auto] [Always]
Power Down Enable [Enabled]
Allows you to enable or disable DDR power down mode.
Conguration options: [Disabled] [Enabled]
ECC Conguration
ECC Mode [Disabled]
Enables or disables the DRAM ECC that allows the hardware to report and correct
memory errors automatically. Conguration options: [Disabled] [Basic] [Good] [Super]
[Max] [User]
Internal Graphics
Primary Video Controller [GFX0-GPP-IGFX-PCI]
Conguration options: [GFX0-GPP-IGFX-PCI] [GPP-GFX0-IGFX-PCI]
[PCI-GFX0-GPP-IGFX] [IGFX-GFX0-GPP-PCI]
GFX0: VGA out port on a graphics card connected into a PCIE x16 slot
GPP: VGA out port on a graphics card connected into a PCIE x1 slot
IGFX Internal VGA out port
PCI: VGA out port on a graphics card connected into a PCI slot
UMA Frame Buffer Size [Auto]
Conguration options: [Auto] [32MB] [64MB] [128MB] [256MB]
Surround View [Auto]
Allows you to disable or enable the Surround View function.
Conguration options: [Auto] [Disabled] [Enabled]
This item becomes user-congurable when you install an ATI graphics card into the PCI
Express x16 slot.
2.4.4 Onboard Devices Conguration
Serial Port1 Address [3F8/IRQ4]
Allows you to select the Serial Port1 base address.
Conguration options: [Disabled] [3F8/IRQ4][2F8/IRQ3] [3E8/IRQ4] [2E8/IRQ3]
Parallel Port Address [378]
Allows you to select the Parallel Port base addresses.
Conguration options: [Disabled] [378] [278] [3BC]