User’s Manual
Table Of Contents
- 本マニュアルについて
- Chapter 1: ハードウェアのセットアップ
- Chapter 2:
- 本機を使用する
- 第3章:
- Windowsの使用
- Chapter 4: Power-On Self-Test (POST)
- Chapter 5: FAQとヒント
- Chapter 6: 付録
- 内蔵モデムの適応規格 (規格/プロトコルなど原文掲載)
- Overview
- Network Compatibility Declaration
- Non-Voice Equipment
- Federal Communications Commission Interference Statement
- FCC Radio Frequency (RF) Exposure Caution Statement
- UL Safety Notices
- Power Safety Requirement
- TV Notices
- Macrovision Corporation Product Notice
- 聴覚障害を防ぐため
- Nordic Lithium Cautions (for lithium-ion batteries)
- CTR 21 Approval (for Notebook PC with built-in Modem)
- Japan JIS-C-0950 Material Declarations
- 筐体のコーティングについて
- 回収とリサイクルについて
- Simplified EU Declaration of Conformity
- 電気・電子機器に含有される化学物質の表示について 
- 日本国内での無線周波数帯のご利用について
ノートPC ユーザーマニュアル 97
This information was copied from CETECOM and is supplied without
liability. For updates to this table, you may visit http://www.cetecom.de/
technologies/ctr_21.html.
1 National requirements will apply only if the equipment may use pulse
dialling (manufacturers may state in the user guide that the equipment
is only intended to support DTMF signalling, which would make any
additional testing superuous).
In The Netherlands additional testing is required for series connection and
caller ID facilities.
Federal Communications Commission
Interference Statement
This device complies with FCC Rules Part 15. Operation is subject to the following
two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a class
B digital device, pursuant to Part 15 of the Federal Communications Commission
(FCC) rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.