user manual

76
ASUS Xonar D2X
I can’t hear any sound from my analog speakers
Instructions:
1. Xonar D2X PCI Express audio card needs the power cable to supply addition
power in addition to the basic PCI Express bus power. Please double
check you have plugged the small 4-pin power plug onto Xonar D2X power
connector. If you did not plug the internal power, Xonar D2X audio center will
remind you a warning message and won’t allow your operation when you
double click Xonar D2X audio center icon in the system tray.
2. Please ensure that you have connected speakers properly and have powered
on your speakers
3. Please ensure that the device master volume or the software player has NOT
been muted on the Xonar D2X Audio Center
4. If you are using Dolby Digital Live or DTS Interactive encoders through the
S/PDIF output, the analog output will be muted to get rid of the interference
between your digital speaker system and analog speakers or headphones.
Please check if this is the case.
5. Please go to the sound and audio device of Windows Control Panel to check
if the playback default device is set to Xonar D2X Audio Device, instead of
other onboard AC97 or HDA codec device or Xonar D2X Audio Converter.
(Xonar D2X Audio Converter is the driver for PMP music converting, not for
normal playback) If it’s not, please set it to Xonar D2X Audio Device and
restart your applications.
6. Please try restart your Windows.
I can’t hear any sound from the S/PDIF output
Instructions:
1. Ensure that you have enabled S/PDIF output in the Audio Center GUI (Main
page)
2. Ensure that you are connecting the correct S/PDIF output jack on the card to
the decoder’s (AV receiver) S/PDIF input jack
3. You may need to select the correct input and mode of your decoder or AV
receiver. For Dolby Digital or DTS output, you may have to double check that
the AV receiver is in that decoding mode.
4. If you are using 192KHz PCM output, please make sure your decoder can
support 192KHz decoding. Try changing it to 44.1K or 48KHz rst.