User Guide

ADSL Modem User’s Manual 9
4 Modem Setup and Driver Installation
This chapter shows you how to set up your Modem for ADSL Internet access.
z Prepare to Install the DSLMON Software and USB Driver
z MPoA Bridge or Routed Setting
z PPPoA or PPPoE Setting
z Connection Status Monitoring
Prepare to Install the DSLMON Software and USB Driver
Before install the AAM6000UG USB ADSL Modem, you should have information below from your
Internet Service Provide (ISP) or Telephone Company. Once the information has confirmed, you may
now choose one of the installation type, “MPoA Bridge/Routed” or “PPPoA/PPPoE”, follow by the
sections below to complete driver installation.
MPoA Bridge/Routed Needed Information
Required Information Default Value Fill in the Blanks
VPI:
The Virtual Path Identifier number identifies a
bundle of virtual channels.
8
VCI:
The Virtual Path Identifier number identifies a
logical connection between end stations.
35
Framing Type & Encapsulation:
Bridge LLC/VC MUX or Route LLC/VC MUX
Bridge LLC
Connection Standard:
ANSI T1.413, G.lite, G.dmt, Multi-Standard
Multi-Standard
IP address: (When using Static IP)
The IP address given from your ISP.
Automatically
Subnet Mask: (When using Static IP)
The subnet Mask given from your ISP.
Automatically
Default Gateway: (When using Static IP)
The default gateway given from your ISP.
Automatically
Preferred DNS Server: (When using Static IP)
Primary DNS server IP given from your ISP.
Automatically
Alternate DNS Server: (When using Static IP)
Secondary DNS server IP given from your ISP.
Automatically