Owner's manual

5-28 Chapter 5: Software support
Use arrow keys to move selection bar on items and press <Enter> to
select.
7. Select Start Create Process and press <Enter> to set up hard disk for
RAID system. The following confirmation message appears:
8. Press <Y> to confirm or <N> to return to the configuration options.
9. Press <Esc> to go back to main menu.
RAID 1 for data protection
1. From the create array menu, select Array Mode, then press <Enter>.
The supported RAID configurations appear on a pop-up menu.
The data on the selected disks will
be destroyed. Continue? (Y/N)
4K
8K
16K
32K
64K
RAID 0 for performance
RAID 1 for data protection
RAID 0/1
RAID SPAN for capacity
RAID 1 for data protection
TIP: For server systems, use of a lower array
block size is recommended. For multimedia
computer systems used mainly for audio and
video editing, a higher array block size is
recommended for optimum performance.
4. Press <Y> to confirm or <N> to return to the configuration options. If
you selected <Y>, proceed to step 9.
5. Select Select Disk Drives, then press <Enter>. Use arrow keys to
select disk drive, then press <Enter> to mark selected drive. An
asterisk appears before a selected drive.
6. Select Block Size, then press <Enter> to set array block size. A list of
valid array block sizes are displayed on a pop-up menu.
2. Select RAID 1 for data protection then press <Enter>.