Operation Manual

PROHEAT II SERIES · AIR/WATER SYSTEM
© FLUIDRA 2016 ALL RIGHTS RESERVED. PROPRIETARY DOCUMENT.
Pag: 22
ENGLISH
temperature is lower than the "Setpoint temperature". The machine starts heating when the
probe temperature is lower than the "Temperature setpoint - Auto mode temperature
differential" and it stops heating when the temperature is higher than the "Setpoint
temperature".
6.4.2. HEAT MODE (PROHEAT II AND PROHEAT II CHILLER MODELS)
Start-up process:
Start-up conditions: Water intake temperature < (Setpoint temperature - Temperature
differential); and the Compressor stop time ≥ Compressor delay time
6.4.3. COOL MODE (PROHEAT II AND PROHEAT II CHILLER MODELS)
Start-up process:
Start-up conditions: Water intake temperature < (Setpoint temperature + Temperature
differential); and the Compressor stop time ≥ Compressor delay time