Aspect Stone~ Peel & Stick Tile E Installation Guide Read this install; manual in its entirety before you start. If you have doubts about doing this installation, you should contact a qualified contractor, carpenter or professional installer. Visit www.aspectideas.com for FAQs, photos and additional information.
of dust, wax, soap scum and grease. Acceptable substrates are drywall, plaster or clean, smooth tile (glazed, porcelain type tile; not porous or textured). Any damaged, loose or uneven areas must be repaired, patched, leveled and primed. Fill cracks and irregularities with wallboard compound or speckling, then sand smooth with fine grade sandpaper.
One popular layout method is to begin from the inside corner of your counter and work across left to right. This method allows you to use two points of reference, your vertical wall and horizontal counter top. Note — when using these two points of reference, be sure to check them for level on the horizontal plane and 90° on the vertical plane. This will prevent any problems as you build your backslash. Lay a 4-foot level on top of your counter top or backslash return lip.
Cutting Tiles If cutting tiles is necessary, use one of our recommended tools and methods listed above. A large tin snip is the recommended cutting tool. Alternative cutting methods include a table saw or chop saw for any necessary straight cuts. Use a combination of a snip and chisel for cutting notches out for various cutouts needed, such as an electrical outlet. Leave on the adhesive liner for measuring, drawing lines and cutting tiles.
Debarring cut tiles If desired, use a metal file to debut the cut edges. Proper position for squaring up an Do not file the edge at an angle edge or smoothing a rough spot Adhering small pieces Use tube adhesive for small cut pieces of Aspect stone that are less than 4 inches by 4 inches. Removing tiles If a tile needs to be removed, apply heat with a hair dryer to soften the adhesive. Use a putty knife on the back side and slowly apply outward pressure to release the tile from the wall.
Stone sealers/enhancers are a durable coating that bonds to the surface of the stone. These products slightly darken the stone color, look wet and have a gloss finish. Sealers/Enhancers, such as Miracle Sealants® 1-Step Natural Stone Sealer and Color Enhancer (or similar products; visit for brand suggestions), provide a high level of stain protection. Follow manufacturer’s directions. Raw stone Stone with sealer To see examples of impregnation and sealer on all stone options visit Circumspection.