User's Manual

Interference

This equipment has been tested and found to comply with the limits for a

class B digital device, pursuant to Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This device may not

cause interference, and (2) This device must accept any interference,

including interference that may cause undesired operation of the device.

This equipment generates, uses and can radiate radio frequency energy and,

if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

1. Re-orient or relocate the receiving antenna.

2. Increase the distance between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

4. Consult the dealer or an experience radio/TV technician for help.

Noise

Electrical pulse noise is present in most homes at one time or another. This

is most intense during electrical storms. Certain kinds of electrical equipment,

such as light dimmers, fluorescent bulbs, motors, fans, etc., also generate

pulse noise. Because radio frequencies are susceptible to this, you may on

occasion hear pulse noise through the speaker. This is usually only a minor

annoyance and should not be interpreted as a defect of the unit.