User Manual

ARTURIA – DrumBrute – USER’S MANUAL 43
6 COPY/ERASE FUNCTIONS
6.1 Copy Bank to Bank
It is possible to copy all 16 patterns from one bank to another bank.
Let’s say you want to copy the patterns from bank C into bank D. Here’s how:
• Press the Bank button.
• Select bank C by pressing Step button 3.
• Press the Copy button. Lots of buttons and pads will flash.
• Press the Bank button again. Step button 3 will flash, which means it is the bank
being copied.
• Select bank D by pressing Step button 4. That button will flash rapidly for about a
second.
When the flashing stops the process is complete. The source bank (bank C in this case)
will still be the selected bank.
6.2 Copy Pattern to Pattern
6.2.1 Within a Bank
This procedure was covered more extensively in section 5.4, but here are the basics. To
copy a pattern to a new location within the current bank:
• Select the source pattern.
• Press the Copy button.
• Press the Ptrn button.
• Press the Step button for the target location. It will flash for half a second, and
then all Step buttons will go dark except one for the original source button.
6.2.2 Between Banks
The following procedure will allow you to copy a single pattern from one bank into a
different bank.
Let’s say you’d like to copy pattern #7 from Bank A to pattern location #15 in Bank B:
• Select Bank A, pattern #7.
• Press the Copy button.
The following procedure will overwrite all 16 patterns in the target bank. Be sure
this is what you want to do before you proceed.